Protection from power disruptions

July 2017 Security Services & Risk Management

Security installations are prone to power problems. These can occur daily and are not only the result of power failures. All electronic security equipment connected to normal mains electricity is vulnerable to power surges, dips, spikes and blackouts.

According to Shane Griggs of PSS Distributors, it is therefore imperative that uninterruptible power supplies and/or surge protection are connected in line with security equipment. Uninterruptible power supplies protect against power surges, dips, spikes and blackouts, while surge protection protects against power surges only, and is a necessity on outside cameras.

Naturally, this comes at a cost, and for a security installation Griggs recommends budgeting between 10% and 20% of the cost of the security equipment for protection equipment. Once the budget is set aside, informed choices can then be made by looking at the solutions available.

“The easiest way to determine your requirements is to add all the equipment’s wattages, get the total maximum wattage draw from the equipment you want to protect with the UPS, and divide this by the output power factor of the UPS (usually found on the brochure of the UPS). Add 30% to this amount to size the UPS.”

If a generator is chosen as a solution, there are some simple rules of thumb that can be applied to choosing the right one, but in some cases, specialist knowledge can prove invaluable. “For the generator, you can use the UPS size multiplied by 1.2, this will give you the generator size. Anything additional you would like to add to the generator must be added. Use the wattage and divide it by 0.8 to accommodate sea level losses – this is a good guideline to size the generator.”

Equipment with start-up currents, such as motors, laser equipment and fluorescent lighting, needs to be worked out slightly differently and it is suggested you speak to a specialist in the field.

It’s one thing to buy equipment, but it’s essential to keep it maintained to get the best working life out of it. Griggs recommends that backup solutions be serviced every six months, or every three months is areas where there are a lot of power failures or dust.

Ultimately, there’s no getting away from the fact that having an independent supply of power is costly. “No matter which decision you opt for, it is very expensive,” says Griggs. “We normally recommend UPSs for up to four hours. Should you require more runtime then we recommend either a generator or solar solution.”

For more information contact Shane Griggs, PSS Distributors, +27 (0)11 608 4259, [email protected], www.pss.co.za



Credit(s)




Share this article:
Share via emailShare via LinkedInPrint this page



Further reading:

The line between locking residents out and restricting their access
News & Events Security Services & Risk Management Residential Estate (Industry)
A June 2026 High Court judgment has clarified one of the most contested issues in modern estate governance: when an HOA's digital access restrictions amount to unlawful self-help or spoliation, and when they do not.

Read more...
Modernise field communications with Push-to-Talk over Cellular
Products & Solutions Security Services & Risk Management
Sentiv is bringing Hytera’s Push-to-Talk over Cellular (PTToC) portfolio to organisations that need a more structured and controlled way to coordinate field teams, without extending a full private radio model to every team, site, or function.

Read more...
SAFPS urges taxpayers to remain alert to fraud
Security Services & Risk Management News & Events
The SAFPS warns taxpayers about evolving SARS scams this tax season, highlighting common fraud tactics, practical prevention tips, and trusted reporting channels to stay protected.

Read more...
Zero-touch automation certificate life cycle management loop
Products & Solutions Information Security Security Services & Risk Management
ManageEngine completes the certificate life cycle management loop with CA-agnostic, zero-touch automation. New post-deployment automation in Key Manager Plus removes the last manual step in certificate renewal as lifespans gradually shrink to 47 days

Read more...
Fire safety in South Africa
Technoswitch Fire Detection & Suppression Technews Publishing SMART Security Solutions Fire & Safety Security Services & Risk Management Editor's Choice
Fire safety is sometimes ignored, sometimes relegated to whatever is cheapest, and sometimes treated with the seriousness it deserves, given that it focuses on protecting life and assets. SMART Security Solutions asked Brett Birch, MD of Technoswitch, for some insights into the realities of fire safety in South Africa.

Read more...
Nimbus remote fire alarm management
Technoswitch Fire Detection & Suppression Security Services & Risk Management Fire & Safety
Nimbus connects key stakeholders to their fire alarm systems, simplifying compliance with fire safety standards and greatly improving visibility into critical events, thereby augmenting first responder processes that save lives and protect assets.

Read more...
Sophos launches AI-native cybersecurity defence system
News & Events Information Security Security Services & Risk Management
Built for a threat landscape reshaped by AI, Sophos Fusion unites security operations, endpoint, network security, identity, email, and cloud into one defence system that prevents, detects, investigates, and responds at AI speed.

Read more...
Stop supplier fraud at the moment of payment
News & Events Security Services & Risk Management
Cape Town-built platform bridges the gap between onboarding and transaction by securing identity inside the live channels where companies exchange invoices and banking details.

Read more...
Ungoverned AI agents and deepfakes pose critical threats
Information Security Security Services & Risk Management
Global study reveals 64% of South African organisations already deploy autonomous AI agents with little to no governance, while 63% of employees admit they are unlikely to be able to spot attacks such as deepfakes

Read more...
A risk-based approach to fire safety
Fire & Safety Security Services & Risk Management Industrial (Industry) Agriculture (Industry)
A report by fire engineering consultancy ASP Fire is challenging blanket assumptions around combustible-core sandwich panels, arguing instead for a rational, risk-based approach that balances fire safety requirements with commercial realities in sectors such as agriculture, manufacturing and industrial processing.

Read more...










While every effort has been made to ensure the accuracy of the information contained herein, the publisher and its agents cannot be held responsible for any errors contained, or any loss incurred as a result. Articles published do not necessarily reflect the views of the publishers. The editor reserves the right to alter or cut copy. Articles submitted are deemed to have been cleared for publication. Advertisements and company contact details are published as provided by the advertiser. Technews Publishing (Pty) Ltd cannot be held responsible for the accuracy or veracity of supplied material.




© Technews Publishing (Pty) Ltd. | All Rights Reserved.