Ultra-low power MCU series enhanced

3 November 2004 DSP, Micros & Memory Integrated Solutions

Texas Instruments has introduced a new family in its MSP430 ultra-low power 16-bit RISC microcontroller line. The MSP430F2xx provides twice the processing performance and half the standby power consumption compared to earlier devices, claims TI, and incorporates enhancements that reduce overall system cost and improve reliability. The MSP430F2xx family features a realtime clock standby mode of less than 1 μA with the ability to switch in under 1 μs to a fully synchronised 16 MIPS active mode. Additional enhancements of MSP430F2xx include an integrated ±2,5% on-chip oscillator, pull-up/pull-down resistors, and increased number of analog inputs. In-system programmable Flash has been improved with smaller 64-byte segments, allowing fast programming times, and a lower 2,2 V programming voltage. Unlike other MCUs, TI says all fail-safe features of the series are available during all modes with no power penalty. The MSP430F2xx is specified for 1,8 V to 3,6 V operation.

Further reading:

Using AMD HLS to supercharge your design performance
DSP, Micros & Memory
This workshop explores the power and capabilities of High-Level Synthesis (AMD Vitis HLS) to dramatically accelerate embedded software to hardware speeds.

Read more...

---

The 8-bit survival syndrome – Part 2
DSP, Micros & Memory
Just like the 4-bit pre-microcontroller, the 8-bit MCU has been finding ways to stick around. Their features and speeds have been improving, offering competitive reasons to work with them.

Read more...

---

Enhanced code protection for USB µC portfolio
Future Electronics DSP, Micros & Memory
To help easily incorporate USB power and communication functionality into embedded systems, Microchip Technology has launched the AVR DU family of microcontrollers.

Read more...

---

General-purpose MCU with RISC-V architecture
EBV Electrolink DSP, Micros & Memory
Renesas has released a general-purpose MCU to enhance its existing RISC-V portfolio, and this is its first MCU using a RISC-V core developed internally at the company.

Read more...

---

8-bit MCU with I3C support
Avnet Silica DSP, Micros & Memory
The PIC18-Q20 8-bit microcontrollers from Microchip easily interface with devices operating in multiple voltage domains, and the built-in I3C interface supports higher-speed and lower-power data transfers than I2C.

Read more...

---

An evolutionary step in customisable logic
Altron Arrow DSP, Micros & Memory
Microchip Technology is offering a tailored hardware solution with the launch of its PIC16F13145 family of microcontrollers, which are outfitted with a new Configurable Logic Block module.

Read more...

---

MCU for battery-powered applications
Altron Arrow DSP, Micros & Memory
Included in ST’s family of devices is the STM32U031, an ultra-low-power MCU featuring an ARM Cortex-M0+ 32-bit core running at up to 56 MHz.

Read more...

---

Serial SRAM up to 4 MB
EBV Electrolink DSP, Micros & Memory
The chips are designed to provide a lower-cost alternative to traditional parallel SRAM products, and include optional battery backup switchover circuitry in the SRAM memory to retain data on power loss.

Read more...

---

SiP supports LTE/NB-IoT and GNSS
RF Design DSP, Micros & Memory
The nRF9151 from Nordic Semiconductor is an integrated System-in-Package that supports LTE-M/NB-IoT, DECT NR+ and GNSS services.

Read more...

---

Qi2 dsPIC33-based reference design
DSP, Micros & Memory
Powered by a single dsPIC33 Digital Signal Controller, the Qi2 reference design offers efficient control for optimised performance.

Read more...

---