Differential video IC operates over Cat-5 cable up to 305 m
10 September 2003Telecoms, Datacoms, Wireless, IoT
Access Control & Identity Management
The first device in a new family of differential receiver/equaliser ICs designed capable of handling video over CAT-5 cable applications at distances typically up to 305 metres, the Elantec EL9110, has been released by Intersil.
Designed specifically for equalising video signals in video switching, the EL9110 features 150 MHz of bandwidth at -3dB and consumes only 33 mA from a 5 V power supply. It can be used for twisted-pair receiving, VGA over twisted-pair and security video applications and features tri-stateable outputs allowing multiple devices to be used in video multiplexing applications.
Intersil has many years experience in high performance analog and op-amp development and the new device family uses this expertise to provide the high performance, low power consumption and reliability required by designers of advanced video switches.
The EL9110 contains a high-speed differential receiver with five programmable poles. The outputs of these pole blocks are summed into an output buffer. Equalisation length is set by the voltage on a single pin. It also provides a tri-stateable output, enabling multiple devices to be used in a multiplexing application. Gain can be adjusted up or down by 6 dB using a voltage gain control signal. An additional 6 dB of gain can be switched in to provide a matched drive into a cable.
For more information contact Arrow Altech Distribution, 011 923 9600, EBV-Electrolink, 021 421 5350 or Memec SA, 011 897 8600.
Wi-Fi 6/BLE module enables rapid development Altron Arrow
Telecoms, Datacoms, Wireless, IoT
Telit Cinterion has announced the WE310K6, a fully integrated, low-power module featuring dual-band, dual-stream Wi-Fi 6, and dual-mode Bluetooth/BLE.
Read more...Low phase noise amplifier RFiber Solutions
Telecoms, Datacoms, Wireless, IoT
The MAAL-011158 from Macom is an easy-to-use low-phase noise amplifier that provides 12 dB of gain in a 32-lead QFN plastic package.
Read more...Full sensor to cloud solution CST Electronics
Telecoms, Datacoms, Wireless, IoT
NeoCortec has demonstrated the seamless and rapid development of full sensor-to-cloud solutions using NeoMesh Click boards from MikroE and the IoTConnect cloud solution from Avnet.
Read more...Analysis of switch-mode power supply: inductor violations Altron Arrow
Editor's Choice Power Electronics / Power Management
Common switch-mode power supply (SMPS) design errors are discussed, and their appropriate rectification is specified, with details on complications that arise with the power stage design of DC-DC switching regulators.
Read more...Microsoft Windows IoT on ARM Altron Arrow
Computer/Embedded Technology
This expansion means that the Windows IoT ecosystem can now harness the power of ARM processors, known for their energy efficiency and versatility.
Read more...Long-range Wi-Fi HaLow module TRX Electronics
Telecoms, Datacoms, Wireless, IoT
One of Mouser’s newest products is the Morse Micro MM6108-MF08651-US Wi-Fi HaLow Module, which adheres to the IEEE 802.11ah standard.
Read more...Quectel launches 3GPP NTN comms module Quectel Wireless Solutions
Telecoms, Datacoms, Wireless, IoT
Quectel Wireless Solutions has announced the Quectel BG95-S5 3GPP non-terrestrial network (NTN) satellite communication module.
Read more...SIMCom’s A7673x series Otto Wireless Solutions
Telecoms, Datacoms, Wireless, IoT
SIMCom recently released the A7673X series, a Cat.1 bis module based on the ASR1606 chipset, that supports wireless communication modes of LTE-FDD, with a maximum downlink rate of 10 Mbps and a maximum uplink rate of 5 Mbps.