Are IP cameras vulnerable to ­cyber attacks?

Residential Estate Security Handbook 2017 Information Security, Surveillance

The Internet of Things (IoT) is currently on the rise and with the expansion of digitisation, the separation between physical security and network security is no longer clear.

Previously, intrusion detection, access control, video surveillance and other physical security technologies operated primarily on analogue infrastructure, while networks, servers, computers, tablet and smartphones operated separately on IP-based infrastructure. The introduction of IP-based infrastructure has changed this and has revolutionised physical security by delivering the benefits of high-capacity, low-latency performance efficiencies and operational cost-effectiveness.

Now, nearly every security camera or sensor technology sold today operates on an Ethernet-based wired or wireless network which means that physical security solutions, like video surveillance systems, are prone to the same types of attacks and exploitations that have inundated data networks for decades. So, how do organisations secure their physical security network to ensure that the very infrastructure that is meant to be protecting business assets isn’t used against them?

It starts with treating the physical security infrastructure and devices in the same manner as network infrastructure and devices. Therefore, protecting everything, right down to switch level.

Analogue vs. IP

Cameras on a modern analogue CCTV system send their video footage in base band format over cabling back to a digital video recorder (DVR) where it is digitised and stored on hard drives. On the other hand, IP cameras broadcast their video as a digital stream over an IP network, and because the video is an IP stream straight from the camera, the DVR is replaced by a network video recorder (NVR) which determines how and where footage is stored.

The analogue system is traditionally more secure given that it is usually physically separated from other network components, but the benefits that can be gained from using an IP-based system mean that the risks thereof need to be properly considered and mitigated.

A single IP device is all it takes

Considering how important a CCTV surveillance system is in protecting everything, from private medical research facilities, to military bases and power generation facilities, the protection of the physical security solution itself has become a concern. Whereas analogue physical security implementations benefited from a certain degree of protection simply by not being connected to other systems, an IP-based CCTV system generally uses the same network infrastructure as the rest of the company.

This means that an attacker no longer needs direct, on-site access to equipment or infrastructure in order to take the system offline, monitor video footage without authorisation, steal or destroy recordings, or modify content. In fact, a single device is all it takes, as an attacker only needs access to one IP-based device (like an IP camera) to potentially gain access to the company’s entire network and digital assets.

Protecting the physical security network

The typical CCTV deployment connects servers and management consoles to IP-enabled cameras and NVRs. Because these systems also need to interact with broader security measures, such as access control systems, alarms and security incident management software – each of these connections is thus a vulnerability.

So how can businesses protect their IP-based CCTV systems from intruders given the ever-expanding nature of the Internet of Things? There are a number of common-sense methods that bear repetition. An IP-based surveillance system needs network protection and it is advisable to use a dedicated network for clients and servers and to separate surveillance from these networks in addition to establishing a secure perimeter with a strong firewall.

There are also specific network access control solutions that have been created to help protect IP devices, like cameras against the threat of viruses and other malicious software, sealing hardware and software devices off from outside attacks and isolating them from the corporate network should they become infected. To tighten up any perimeter weakness, organisations should use port protection to set up switches within their networks and restrict user access to certain parts of the network.

These are available as pre-staged servers that are available as pre-configured 8-port or 24-port switches that make for an easy setup. By placing protection at a port level, it becomes possible to add switches and quickly allow or block devices. These protective appliances usually have display panels that provide information on the network, such as the device IP and MAC addresses, port number the devices are connected to on the switch and authentication status.

In the event of an unauthenticated device, an alarm will be triggered in the video management system, even if the appliance is turned off. These alarms provide information about the detected device and its connected network port, allowing the security operator to take immediate informed action. By placing intelligent security at switch level, it is possible to effectively cover the vulnerabilities presented by the IoT in that it is now possible to protect a company’s network from an unknown device gaining unauthorised access, automatically. If an unknown device attempts to log on to a network, it is blocked from the rest of the network, quarantined and reported, before the intruder has a chance to do any harm.

It’s important for businesses to remember that an IP-camera, just like any IP-device, is no longer just a product or a device – it is a vulnerability and it is time to start treating everything on the physical security network in the same vein.

For more information contact Graphic Image Technologies, +27 (0)11 483 0333, laurence@git.co.za, www.git.co.za



Credit(s)




Share this article:
Share via emailShare via LinkedInPrint this page



Further reading:

Pentagon appointed as Milestone distributor
Elvey Security Technologies News & Events Surveillance
Milestone Systems appointed Pentagon Distribution (an Elvey Group company within the Hudaco Group of Companies) as a distributor. XProtect’s open architecture means no lock-in and the ability to customise the connected video solution that will accomplish the job.

Read more...
Deception technology crucial to unmasking data theft
Information Security Risk Management & Resilience
The ‘silent theft’ of data is an increasingly prevalent cyber threat to businesses, driving the ongoing leakage of personal information in the public domain through undetected attacks that cannot even be policed by data privacy legislation.

Read more...
Data security and privacy in global mobility
Risk Management & Resilience Information Security
Data security and privacy in today’s interconnected world is of paramount importance. In the realm of global mobility, where individuals and organisations traverse borders for various reasons, safeguarding sensitive information becomes an even more critical imperative.

Read more...
Sophos celebrates partners and cybersecurity innovation at annual conference
News & Events Information Security
[Sponsored] Sun City hosted Sophos' annual partner event this year, which took place from 12 to 14 March. Sophos’ South African cybersecurity distributors and resellers gathered for an engaging two-day conference.

Read more...
Re-imagining business operations with the power of AI
AI & Data Analytics Surveillance
inq., a Convergence Partners company, has introduced a range of artificial intelligence (AI) solutions to assist organisations across industry verticals in optimising business operations and improving internal efficiencies.

Read more...
Enhance control rooms with surveillance and intelligence
Leaderware Editor's Choice Surveillance Mining (Industry)
Dr Craig Donald advocates the use of intelligence and smart surveillance to assist control rooms in dealing with the challenges of the size and dispersed nature common in all mining environments.

Read more...
The CIPC hack has potentially serious consequences
Editor's Choice Information Security
A cyber breach at the South African Companies and Intellectual Property Commission (CIPC) has put millions of companies at risk. The organisation holds a vast database of registration details, including sensitive data like ID numbers, addresses, and contact information.

Read more...
Navigating South Africa's cybersecurity regulations
Sophos Information Security Infrastructure
[Sponsored] Data privacy and compliance are not just buzzwords; they are essential components of a robust cybersecurity strategy that cannot be ignored. Understanding and adhering to local data protection laws and regulations becomes paramount.

Read more...
AI augmentation in security software and the resistance to IT
Security Services & Risk Management Information Security
The integration of AI technology into security software has been met with resistance. In this, the first in a series of two articles, Paul Meyer explores the challenges and obstacles that must be overcome to empower AI-enabled, human-centric decision-making.

Read more...
Milestone Systems joins CVE programme
Milestone Systems News & Events Information Security
Milestone Systems has partnered with the Common Vulnerability and Exposures (CVE) Programme as a CVE Numbering Authority (CNA), to assist the programme to find, describe, and catalogue known cybersecurity issues.

Read more...